Without putting a test meter on the circuits, I conclude the three electronic ballasts are "bad." What do you suggest I do to correct this problem, rather than removing and replacing my current fixtures? How should I "wire around the ballasts," as I am reading in quite a number of internet posts to influence my LED tubes to work as designed? Or, what should I do to, as you indicate, replace the ballasts with "drivers?" Thanks for your timely communications and guidance. I then replaced those LED tubes with T8 fluorescent tubes. They all worked beautifully until approximately one month ago, when three of the five fixtures "went dark." I replaced the LED tubes w/new tubes of the same type. In some countries the mains have one 'hot' wire, which has the full mains voltage, and one 'cold' wire which has zero Volts to ground, or just a few volts. I want to solder the ACN (blue) and ACL (brown) wires to an outlet plug I cut that has copper wire (black and white). One year ago, I removed the T8 fluorescent tubes and replaced them with LED tubes. Ask Question Asked 7 years, 5 months ago Modified 4 years, 8 months ago Viewed 46k times 2 I have a 12v 5.0a AC to DC power converter. Howdy: Approximately two years ago, I installed five new 110v, 2-tube 4-feet long, T8 fluorescent fixtures having "electronic" ballasts, in a series line (ballasts for each of the five fixtures are wired in parallel to the line) in my residential garage.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |